Hi Razor103,
I have built two printers...the standard prusa with the regular 200 x 200 bed and my own design with has a 304 x 304 (12"x12") bed. The second is made from extruded aluminum 1010 series and uses a vslot x axis. motors on the bottom instead of the top. I tired to fix some of the issues with the prusa (reinventing the wheel, probably, but sometimes reinventing is much more fun than following someone else's instructions.)
I am in St pete so Apollo Beach is a bit of a drive for me. I was involved with the Tampa Bay MicroController and Robotics club that was meeting at MOSI and have interacted with Tom in the robotics lab over there. I am afraid my knees make driving a bit painfull for long drives, but I would like to get envolved in a semi regular basis.
I have built two printers...the standard prusa with the regular 200 x 200 bed and my own design with has a 304 x 304 (12"x12") bed. The second is made from extruded aluminum 1010 series and uses a vslot x axis. motors on the bottom instead of the top. I tired to fix some of the issues with the prusa (reinventing the wheel, probably, but sometimes reinventing is much more fun than following someone else's instructions.)
I am in St pete so Apollo Beach is a bit of a drive for me. I was involved with the Tampa Bay MicroController and Robotics club that was meeting at MOSI and have interacted with Tom in the robotics lab over there. I am afraid my knees make driving a bit painfull for long drives, but I would like to get envolved in a semi regular basis.